Home / Alcolmeters / Lion 500 Alcolmeter

Lion 500 Alcolmeter

Posted on: 01-4-2011 Posted in: Alcolmeters

  • Simple to use the lion alcolmeter is fully automatic
  • Fast accurate analysis
  • Easy to read display
  • Last Test Recall
  • True Evidential Capability
  • Calibration
  • Ergonomic Design
  • Low power consumption
  • Simple, Low cost mouthpiece
Model Lion 500
Analytic Principle Lion fuel censor for alcohol analysis. Unaffected by acetone, hydrocarbons, non-alcoholic food and drug vapours, and all other likely breath contaminants.
Measure Range 0.02 to 2.00mg/litre; .005 to .400% BAC (g/210 litres).  An over-range option is given at higher levels.  An optional Zero, Pass, Warn, Fail readout is also available.
Breath Sampling The 500 automatically samples deep-lung air.  An optional manual override feature may also be used if required.
Analytical Response Time Normally within 30 seconds at the ‘zero’ alcohol level
Recovery Time Approximately 100 seconds at 0.50mg/l
Operating Temperature (Optimum) -5˚C to +40˚C
Storage Temperature -20˚C to +65˚C
Power supply 2 x AAA cells provide sufficient power for around 400 breath tests.  Two stage low power warning system.
Humidity 10 to 95%, non-condensing
Barometric Pressure 600 to 1,300hPa
Calibration Recommended every 6 months, using either a wet-bath simulator, or an AlcoCal dry-gas standard. Automatic, security-protected procedure.
Display LCD graphics, dimensions 45mm x 21mm, 128 x 64 pixels, with backlighting
Audible Beeper Gives auxiliary warning messages
Microcontroller H8/3664
Memory The last test is stored memory, for later recall if required, even after switching
Warm-up time The instrument is not heated, so there is no warm-up time at any ambient temperature
Disposable mouthpiece Simple disposable ‘pressure’ tube, the same as used with the S-D2/S-L2
RFI Certification Exceeds requirements of EN 50081-1:1992 (emission) and EN 50082-1:1997 (immunity).  In the UK, complies with the Home Office/ACPO 2002 requirements in respect of immunity TETRA
Vibration and shock Meets IEC 68-2-27 Part 2.1 Test EA and IEC 68-2-6 Part 2.1 Test FC
Case Construction Impact resistant ABS
Exterior Dimensions (W x D x H) 125 x 654 x 15mm
Weight Approximately 140g, including batteries

AloCal-M

Designed to read breath alcohol at a high level of accuracy.

  • WEIGHT: 0.120kg
  • DIMENSIONS: 223x66mm
  • Shelf life of 6 months
  • Maximum filling pressure 10.0 bar
  • Number of samples approx. 50
  • Accuracy ± 10% of stated alcohol concentration
  • Supplied with explanatory booklet

Includes:

  • Low pressure disposable canister
  • Dispensing cap with connector tube
  • Typically used by customers with single instrument and a low test rate

AlcoCal 2AL

Designed to read breath alcohol at a high level of accuracy.

  • Includes regulator and 10 AlcoCal® connector tubes
  • WEIGHT: 0.758kg
  • DIMENSIONS: 283x74mm
  • Shelf life estimated from 24 to 36 months
  • Maximum filling pressure 34.5 bar
  • Number of samples approx. 300
  • Accuracy ± 3% of stated alcohol concentration
  • Supplied with explanatory booklet and 10 connector tubes

Includes:

  • High pressure disposable cylinder
  • Re-usable regulator/contents gauge

 Nasal Tubes

  • Pack of 500

Protective Pouch

  • Grey – For use with Lion 500

Protective Pouch

  • Yellow – For use with Lion 500 

Lion 500 Brochure